HT Pro Archives » Page 4 of 4

You are here:

Configuring a Core 3 (C3) Tracker

Timers

October 4, 2021

This section of the Core 3 (C3) config contains the settings which determine the intervals at which a tracker should communicate with the server, or perform an action. Start / Stop: this determines the minimum amount of time the tracker should register no motion before it enters ...

Emergency Call / RF Forwarding

October 4, 2021

This section of the Core 3 (C3) config contains the settings which determine whether the tracker should attempt a voice call in the event of Emergency. Emergency Call If a C3 tracker is fitted with a microphone, it is possible to listen-in by instructing the tracker to create a phone call...

Power Modes (C3)

October 4, 2021

This section of the Core 3 (C3) config contains the settings which determine which Power Mode the tracker should operate in. The details of each are given below. Power Modes Power Modes (abbreviated to ‘PM’) are pre-set instructions for when the GSM and GPS antennas of the tracker should ...

Misc. Settings

October 4, 2021

This section of the Core 3 (C3) config contains a number of miscellaneous settings and statistical items related to the tracker. Accessed by clicking on Power Mode, misc. settings, this section of the C3 configuration covers a wide variety of settings which fall outside of other categories. ...

Commands

September 28, 2021

This section of the Core 3 (C3) configuration contains a list of commands and settings related to the device receiving commands from the HT Server software. Log: this instruction will cause the tracker to completely clear its internal log of all stored messages. If there is a large q...

HT Pro

Configuring a Core 3 (C3) Tracker

Timers

Emergency Call / RF Forwarding

Power Modes (C3)

Misc. Settings

Commands

United Kingdom (HQ)

United States

Configuring a Core 3 (C3) Tracker

Timers

Emergency Call / RF Forwarding

Power Modes (C3)

Misc. Settings

Commands

Start typing and press enter to search